SmallEngineVelocity
Image of PLUG and PLAY Push Button Harness [GET and ATR Harness]

PLUG and PLAY Push Button Harness [GET and ATR Harness]

$18.99 - $23.99 - Sold out

Please see WOT channel who did an install video
https://www.youtube.com/watch?v=YsRevJh278Y

UNSURE if this works on a CHUCKUS

Plug and play harness to add a push-button start. There is an option for WITH or WITHOUT button so please be sure to choose.

You will notice a look in the harness and that is the bypass for the kill switch. If you have an NCY CDI or you are using it on an ATR v4 harness on your get leave it alone, if you do not you can cut the loop and wire in a kill switch if you want. Contact me if you have any questions.

When you receive the product PLEASE make sure the pins are straight because they may become misaligned in shipping and if you just "jam" the connector on you may bend a pin. Just a warning since this is carefully made while at home trying to make cool products.

GET Setup:
1. Unplug the right side controls
2. Plug this in
3. Mount your button and connect the two wires.

ATR Harness for GY6 swap:
1. Unplug the right side controls
2. Plug this in
3. Mount your button and connect the two wires.

PLEASE CHOOSE WITH OUR WITHOUT A BUTTON ON THE OPTIONS.

The preferred button needs to be a momentary switch [Normally Off] You can use a lighted switch or a plan button but needs to be a momentary switch. This is just the harness. I figure you can customize the button whatever you want it to be.

There is a simple install guide that it comes with.

The button I like to use:
https://amzn.to/37gFUKc

Your bag is empty
Start shopping